FAQ

The ReCovers are universal, and therefore work with all smartphones. It does not matter if you use the phone with or without phone case. 

ReCover is only NOT compatible with foldable phones, or foldable (book-like) phone cases. Read our Size Guide Here.

Yes, you can also use ReCover if you do not have a phone case. In that case we recommend using the o-rings. You can put them on the grips to prevent the cover from slipping off your phone.

ReCover comes in two sizes: one standard size, and one smaller size:

– The standard size works for most phones, also the bigger ones (i.e.: Samsung S24 Gamma, Ultra, iPhones Max and Plus).

– The small size is specifically designed for smaller phones like the iPhone Mini and iPhone, but it fits perfectly the newer standard iPhones when used without a phone case.

The size difference between both ReCovers are 6 mm in width and 9mm in height. Read our Size Guide Here.

The ReCovers are locally produced in the Netherlands, specifically in the province of Utrecht. They have been designed, tested and produced in Europe.

The ReCovers are produced with Multi Jet Fusion (MJF)  industrial 3D printing. Specifically, we use HP’s Multi Jet Fusion high reusability technology, in which the parts (the flat cover and the two grips) are created by spreading a thin layer of powdered material and then using a printhead to apply fusing and detailing agents. Heat is then applied to fuse the powder where needed, layer by layer, until the object is fully built.

The ReCovers are made from 100% high-reusability HP-PA12, also known as nylon 12. This is a strong, durable thermoplastic which can resist extreme weather, heat, UV light, and impacts, ensuring long-term stability. The material is also water resistant.